Installed toilet paper holder into the front panel.
Toilet paper holder
New set of tiles
Dolphin, wheel, pelican, ship’s bell, sand dollar, and a bikini.
Accumulation tank installed
Second to last piece of the puzzle is in. The Shurflo accumulation tank is plumbed in. Only the water pump is left now.
Installed backing board & cut custom tiles
With 2 sets of tiles ready, today was the day to dry fit the entire assembly and figure out the last row. Ended up with 5 custom pieces that will be done next week. Will likely rotate the tiles in the final layout (and need to figure out which one goes where). Teak border is also just FPO right now, needs more work to have smooth edges and better bottom shape.
We got hot water!
Tested the water heater and things are working great. Pretty awesome to have hot water on a boat!
First toilet flush test
Well, after all the hoses and wires were connected the toilet appeared to be dead. As I started troubleshooting, I realized that an inline fuse holder was wired into the +12V wire from the battery but I never actually put a fuse in it! Once that was fixed, we were in business. No leaks, no troubles. Happy!
The 2nd set of tiles is ready
Picked up the second set of tiles today: an octopus, jellyfish, whale tail, anchor, crab, Golden Gate Bridge, and the Big Dipper pointing to Polaris. Looking pretty good.
First test of the plumbing
Performed the first test of the pluming by connecting a hose to the city water inlet. Almost everything worked just fine. So awesome to have faucets in the galley and head working! A few leaks showed up but I think all of them can be fixed with adding plumbers tape. Off to a good start!
Head sink drain
Plumbed in head sink to seacock.
Galley sink drain
Spliced in a Y joint into the drain line and connected galley sink to it. Royal pain
